Fungicide considerations and disease identification in wheat

Author:  Comments Off on Fungicide considerations and disease identification in wheat

While I have not heard of any reports of diseases in wheat in Tennessee, as we get closer to flag leaf it will be important to be scouting for diseases. To better guide fungicide decisions, one first needs to correctly identify what disease they are trying to manage. Resources on both disease identification and fungicide selection can be found on the new, mobile-friendly field guide at guide.utcrop.com.

Major diseases of concern include stripe rust and leaf rust of wheat. There have been reports of rust to the south, there’s still not any near Tennessee or its borders. Rust spores usually cannot survive northern winters and have to be blown in from the south each year, (see Figure 1 – wheat rust pathways from http://www.ars.usda.gov/Main/docs.htm?docid=9757 which also contains specific reports on rust in wheat).

Figure 1. Wheat rust pathways in the U.S.

Stripe rust (caused by the fungus Puccinia striiformis) has a cooler, optimal temperature range (50 to 64 °F) and intermittent rain or dew promotes infection and disease development. Stripe rust is best identified by tiny, yellow to bright orange pustules that form distinct stripes on the leaves (Image 1 and 3).

 

Image 1 – Usual symptoms of stripe rust on wheat

Leaf rust (caused by the fungus Puccinia triticina) has a warmer, optimal temperature range (64 to 77 °F) along with high humidity or moisture to promote infection and disease development. Symptoms of leaf rust include small round or oblong raised pustules that are orange red in color. Leaf rust pustules are more scattered and larger in size compared to stripe rust (Image 2 and 3).

 

Image 2. Orange pustules of leaf rust
Image 3. Leaf rust pustules on left are darker orange and larger than the stripe rust pustules which are arranged in a line on right side of leaf.

Two other common diseases observed in Tennessee include septoria leaf blotch (Septoria tritici) and stagonospora leaf/glume blotch (Stagonospora nodorum). The leaf lesions look very similar and usually begin in the lower canopy and progress upward, with the latter disease also causing discoloration on the glumes (Image 4 and 5). Some injury, such as fertilizer burn or freeze damage on the leaves, can look very similar to these diseases. Noticing where in the canopy the symptoms are seen and if they are progressing will help distinguish injury from disease. More information on these diseases and others can be found at guide.utcrop.com as well as at UTcrops.com.

Image 4. Septoria-Stagnospora leaf blotch
Image 5. Glume blotch

The decision to apply a fungicide to wheat should be based upon multiple factors including: 1) disease presence, 2) fertility and yield potential, 3) weather conditions and 4) cropping history. A detailed foliar fungicide point system can be found at UTcrops.com (Wheat Foliar Fungicide Point System) that can be used as a guide to determine the need for a fungicide application.

Fungicide applications in wheat are most beneficial after the flag leaf has emerged (Feekes 9 or later growth stage), since the flag leaf can make up approximately 75% of the leaf area that contributes to grain fill. Fungicide application can be delayed further if no disease is present and/or there is low disease risk.

The next crucial time period for fungicide application is beginning bloom (Feekes 10.5.1) to protect from Fusarium Head Blight (Head Scab). Consult the Fusarium Head Blight Prediction Center at http://www.wheatscab.psu.edu/ for Head Scab forecasts for your area and the “Wheat Fungicide Table” at UTcrops.com for more information on fungicide products and their efficacy against different wheat diseases. Additional information on wheat can be found at UTcrops.com and on the Wheat Quick Facts – https://news.utcrops.com/wp-content/uploads/2015/10/W321_2015.pdf

Print Friendly, PDF & Email